AIRTRONICS M12 Betriebsanweisung PDF herunterladen (Seite 66)













P1 though P6 setting range is H100 to L100. The default setting for P1 is L100, for P2 is L60, for P3 is L20, for P4 is H20, for P5 is

H60 and for P6 is H100. These values are a percentage of Auxiliary 2 servo travel.

Changing the Auxiliary 2 Point Values, Continued....

3) Scroll UP or DOWN to highlight the desired Point value you would like to

change.

4) Press the ENTER key, then scroll UP or DOWN to change the Point value.

Choosing an H or L value will determine the direction the servo travels.

5) Press the ENTER key, then repeat steps 3 and 4 to change any other desired

Point values.

6) Cycle forward and backward through the Points using the Auxiliary Dial or the Trim Switch you Assigned AUX2 to. You

will notice that as you cycle through the Points, the current Point will be highlighted and in addition, the current Point will be

displayed in a pop-up window.











The Motor on Axle Mixing function provides you with two Throttle channels. It is typically used for Rock Crawlers and allows you

to control either the Front and Rear motors together or independently, giving you Dig and Burn functions. In addition, you can

variably change the power distribution between the Front and Rear motors, allowing you the utmost in functionality.

Use one of the five Trim Switches, the Auxiliary Dial or the Auxiliary Lever to Activate the Dig and Burn functions while you're

driving.

When using the Motor on Axle function, it's important to adjust the F/TH channel and R/TH channel Sub-Trim values so

both motors are OFF when the Throttle Trigger is in the Neutral Point. In addition, remember, you are able to adjust many

functions, such as Exponential, Servo Speed and much more for each Throttle channel independently to allow for the optimum

Motor on Axle Mixing setup.

The Motor on Axle Mixing function is available only when either Car Type IX or Car Type X is Selected.

1) From within the SETUP menu, scroll UP or DOWN to highlight the MOA MIX

menu.

2) Press the ENTER key to open the MOA MIX menu. 100 [FRONT] : 100 [REAR]

will be highlighted.

3) Press the ENTER key, then scroll UP or DOWN to change the Power Distribution

between the Front and Rear motors. Reducing the [REAR] value will reduce

the available power to the Rear motor (Dig) and reducing the [FRONT] value

will reduce the power to the Front motor (Burn).

Use the Servo Monitor at the bottom of the MOA MIXING screen to view

Throttle channel output.

Choosing the Motor on Axle Power Distribution Values:

You are able to program Dig and Burn functions by changing the Power Distribution between the two motors. When both Front

and Rear values are balanced, Dig and Burn functions are Inhibited.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 115 116

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRTRONICS M12 Betriebsanweisung Seite 66

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen AIRTRONICS M12