AIRTRONICS M12 Betriebsanweisung PDF herunterladen (Seite 51)















The VOLT menu allows you to change the way receiver battery Voltage information is displayed on the TELEMETRY screen ALL

and VOLT pages and when the receiver battery Low Voltage Alert alarm sounds. For example, the Maximum Voltage value can

be adjusted to calibrate the VOLT Indicator on the TELEMETRY screen ALL page. In addition, you can adjust the Voltage value that

the receiver battery Low Voltage Alert alarm will sound at to match the type of receiver battery you're using.

2) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN

to highlight the VOLT menu.

Changing the Maximum Voltage Value:

1) From within the SYSTEM menu, scroll UP or DOWN to highlight the LOG SETUP

menu.

3) Press the ENTER key to open the VOLT menu. MAX VOLT > 9.0V will be

highlighted.

4) Press the ENTER key, then scroll UP or DOWN to choose the desired Maximum

Voltage value. This value determines the Maximum Voltage that will be

displayed on the TELEMETRY screen VOLT page and also calibrates the VOLT

Indicator on the TELEMETRY screen ALL page. We suggest using a value that

matches as closely as possible the peaked voltage value of your receiver

battery after it's pulled off your charger.

MAX VOLT setting range is 3.0V to 9.0V. The default setting is 9.0V.

The Maximum Voltage value cannot be set Lower than the Alert Voltage value. If necessary, you may need to Lower the Alert

Voltage value prior to lowering the Maximum Voltage value.

Changing the Alert Voltage Value:

The Alert Voltage value determines the voltage at which the receiver battery Low Voltage Alert alarm will sound. For example, you

can set the Alert Voltage value to alert you to when your Model's receiver battery is getting low and needs to be recharged. When

the Alert Voltage value is reached, the Voltage Alert alarm will sound and LED2 will flash. The Low Voltage Alert alarm will sound

for approximately 5 seconds, however, LED2 will continue to flash until you recharge the receiver battery. The audible portion of

the Low Voltage Alert alarm can be cleared by pressing the BACK or ENTER keys.

1) From within the VOLT menu, scroll UP or DOWN to highlight ALERT VOLT > 3.8V.

2) Press the ENTER key, then scroll UP or DOWN to change the Alert Voltage

value. The Alert Voltage value is the voltage that the receiver battery Low

Voltage Alert alarm will sound at.

ALERT VOLT setting range is 3.0V to 9.0V. The default setting is 3.8V.

The Alert Voltage value cannot be set Higher than the Maximum Voltage value. If necessary, you may need to raise the

Maximum Voltage value prior to raising the Alert Voltage value.

IMPORTANT: Refer to the manufacturer of your Model's receiver battery to determine the safest Alert Voltage value to use. In

general, the Alert Voltage value should be high enough to alert you when it's time to recharge your receiver battery, but not so

low that the receiver can no longer control your Model or operate your servos optimally.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRTRONICS M12 Betriebsanweisung Seite 51

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen AIRTRONICS M12