9
MX
-
V 3
-
CHANNEL 2.4GHZ RADIO SYSTEM USER'S GUIDE
LCD AND PROGRAMMING KEYS
Cycles down through the list of menus and sub-menu
functions you would like to make programming changes to.
Press the MENU UP and MENU DOWN keys at the same
time to display the Voltage Monitor.
Cycles up through the list of menus and sub-menu functions
you would like to make programming changes to. Press
the MENU UP and MENU DOWN keys at the same time to
display the Voltage Monitor.
PROGRAMMING KEY NAME FUNCTION
Increases Programming Values and used to select models.
Press the INCREASE and DECREASE keys at the same time
to reset Programming Values to default.
Decreases Programming Values and used to select models.
Press the INCREASE and DECREASE keys at the same time
to reset Programming Values to default.
MENU UP
MENU DOWN
Selecting menus and programming the transmitter is accomplished using the four programming keys.
INCREASE
DECREASE
TRANSMITTER AND RECEIVER bINDING
The Binding function allows you to bind the transmitter and receiver pair. When new, it is necessary to pair the transmitter and
receiver to prevent interference from radio controllers operated by other users. This operation is referred to as 'binding'. Once
the binding procedure is complete, the setting is remembered even when the transmitter and receiver are turned OFF, therefore,
this procedure usually only needs to be done once. Bind codes are unique to each transmitter and receiver pair, so you can bind
multiple receivers to the same transmitter.
Before beginning the binding procedure, connect the switch harness, servos and the receiver battery to your receiver, using
the diagram on page 8. Make sure that both the transmitter and the receiver are turned OFF.
The transmitter is compatible with FH2 receivers, however, the transmitter is also
compatible with FH2F and DS2 receivers. To bind the transmitter to an FH2F or DS2
receiver (not common in North America), the transmitter Modulation Type must first be
changed. For more information, see the
Modulation Type
section on page 18.
1) Turn the transmitter ON. The Power Indicator on the transmitter will illuminate red.
When the binding procedure is successful, the Bind LED on the receiver will stay solid blue when both the transmitter and
receiver are turned ON. If the Bind LED on the receiver is flashing rapidly or not illuminated at all, the transmitter and receiver
are not paired. In this case, turn both the transmitter and receiver OFF, then repeat the binding procedure again.
Under some circumstances, the receiver may not operate after turning the transmitter and receiver ON. If this occurs,
perform the binding procedure again.
3) Quickly press the Bind Button on the transmitter. The Bind LED on the receiver will flash
rapidly, go out momentarily, then illuminate solid blue, indicating the binding procedure
is complete.
2) While holding down the Bind Button on the receiver, turn the receiver ON. The
Bind LED on the receiver will flash slowly. Release the Bind Button. The Bind
LED on the receiver will continue to flash slowly.
You must complete step 3 below within 10 seconds after pressing the Bind
Button on the receiver or you will need to start the binding procedure over.
(8 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern