8
MX
-
V 3
-
CHANNEL 2.4GHZ RADIO SYSTEM USER'S GUIDE
RECEIVER CONNECTIONS AND MOUNTING
Use the diagram below to make the connections to the 92625 (RX-37E) 3-Channel 2.4GHz FHSS-2 receiver included with your MX-V
3-Channel 2.4GHz FHSS-2 radio control system.
The receiver's Nominal Input Voltage is 4.8 ~ 7.4 volts. A 2 cell Li-Po or 2 cell Li-Fe battery pack can be used to power the
receiver without the use of a voltage regulator. In addition, this allows you to take advantage of the higher torque and speed
provided by using 7.4 volt digital servos.
Use a 2 cell Li-Po or 2 cell Li-Fe battery pack ONLY if your servos are rated to handle the higher voltage.
If you're using an Electronic Speed Control with BEC circuitry, verify that it reduces the voltage to
between 4.8 and 7.4 volts before making your connections and turning your radio control system ON.
• We suggest binding the transmitter and receiver and making all receiver connections to check for correct
operation prior to mounting the receiver in your model.
• The receiver should be mounted as far away from any electrical components as possible.
• Route the receiver antenna up through a plastic tube so that it is in the vertical position.
• To protect the receiver from vibration and other damage, we recommend wrapping the receiver in shock
absorbing foam or using double-sided foam tape when installing it in your model.
As a safety precaution, set your model on a stand so the wheels are off the ground before turning on your radio control
system or connecting your motor for the first time.
Antenna
Tube
Antenna
Wire
Do not use servos rated for 4.8 or 6.0 volts with a 2S Li-Po or Li-Fe receiver battery pack or damage to the servos
could result.
Steering
Servo CH1
Throttle
Servo CH2
Auxiliary
Servo CH3
Switch (Included)
Receiver
Receiver
Switch
To Battery
To Motor
ESC
Batt
Steering
CH1
Auxiliary
CH3
'AA' Dry Cell Battery Holder (Included),
4.8v ~ 6.0v Ni-Cd/Ni-MH or 2S Li-Po or 2S Li-Fe
GLOw/GAS
OR MSC
SETUP
ESC
SETUP
LCD AND PROGRAMMING KEYS
The transmitter features four programming keys that are used to facilitate transmitter programming. The programming keys
consist of four different keys - the MENU UP key, the MENU DOWN key, the INCREASE key and the DECREASE key. These four
keys are used to program the functions of your transmitter, select saved models and change the Modulation Type. This section
summarizes the functions of each of the four programming keys, in addition to describing the main areas of the LCD screen
Model Number: Displays the model that is currently loaded into memory. Up to 10 different models can be stored.
Menu Selections: Displays the available Programming Menus. The currently Active menu will flash. The information displayed in
the Programming Window will vary based on the menu selected.
Programming Window: Displays transmitter programming information. When the transmitter is turned ON, the BATT menu will
be selected, the current model number will be shown and the Voltage Monitor will display the transmitter's current voltage.
Voltage Monitor: Displays the current voltage of the transmitter batteries. When the transmitter batteries reach 4.6 volts, the Low
Voltage Alarm will sound.
Programming Window
Menu Selections
Voltage Monitor
Model Number
Menu Selections
(8 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern