AIRTRONICS MX-V Betriebsanweisung PDF herunterladen (Seite 17)

V 3

CHANNEL 2.4GHZ RADIO SYSTEM USER'S GUIDE

SUb-T - SERVO SUb-TRIM

Changing the Steering Servo Sub-Trim Value:

1) Press the MENU UP or MENU DOWN keys to open the SUB-T menu. SUB-T will

flash and ST 0 will be displayed.

2) Press the INCREASE or DECREASE keys to adjust the Steering Servo Sub-Trim

value either Right or Left to center the servo horn (or servo saver). The direction will

differ based on the steering channel's Servo Reversing setting.

SUB-T ST setting range is R25 to L25. The default setting is 0.

After adjusting the Servo Sub-Trim values, use the End Point Adjustment function to set the desired amount of maximum

servo travel in both directions. For more information, see the

End Point Adjustment

section on pages 11 through 13.

Changing the Throttle Servo Sub-Trim Value:

1) From within the SUB-T menu, press the MENU UP or MENU DOWN keys to display

TH 0.

2) Press the INCREASE or DECREASE keys to adjust the Throttle Servo Sub-Trim

value either Forward or Brake to center the servo horn (or adjust it's Neutral point).

The direction will differ based on the steering channel's Servo Reversing setting.

SUB-T TH setting range is F25 to B25. The default setting is 0.

The Servo Reversing function allows you to electronically switch the direction of servo travel. For example, if you rotate the steering

wheel to the right and your model turns left, you can use the Servo Reversing function to make your model turn right. The Servo

Reversing function can be adjusted for the Steering channel, Throttle channel and Auxiliary channel 3.

When you change the direction of Steering or Throttle servo travel, the servo horn may no longer be centered. If this occurs,

use the Servo Sub-Trim function to center the servo horn(s). For more information, see the

Servo Sub-Trim

section above

and on the previous page.

REV - SERVO REVERSING

Changing the Servo Reversing Values:

1) Press the MENU UP or MENU DOWN keys to open the REV menu. REV will flash

and ST NOR will be displayed.

2) Press the MENU UP or MENU DOWN keys to choose which channel you would like

to change the Servo Reversing value for, then press the INCREASE or DECREASE

keys to change the direction of servo travel.

REV setting range is NOR and REV. The default setting for all channels is NOR.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

AIRTRONICS MX-V Betriebsanweisung Seite 17