AIRTRONICS MX-V Spezifikationen PDF herunterladen (Seite 11)

Page 11

Charging the battery

SAFETY PRECAUTIONS AND CHARGING WARNINGS

The M11X FHSS-3 2.4GHz transmitter features a 6 cell 7.2v 1500mAH NiMH battery for lighter weight and longer battery life.

The battery is charged directly through the transmitter, using the charging jack located at the base of the grip. Please observe the

Safety Precautions and Charging Warnings below when charging the transmitter battery.

Always follow the charging procedures described below to ensure safe and correct use of your NiMH battery.

The NiMH battery is not charged when purchased. It is necessary to charge the NiMH battery before operation.

Before charging the NiMH battery, double-check that the transmitter power switch is in the OFF position.

Overcharging reduces the life of the battery and can result in electrolyte spills, overheating, and bursting. This may cause

personal injury and/or property damage.

Do not plug the charger into anything other than an AC 110v power outlet. Plugging the charger into anything other than

AC 110v outlet may result in smoking, sparks, or re.

Do not throw the NiMH battery or abuse it in any manner. Do not dispose of the NiMH battery in the re or allow it to overheat.

Do not short-circuit the NiMH battery terminals with wire or any other object.

USING A TRANSMITTER LIPO BATTERY

An after-market Li-Po battery can be used in place of the stock 6 Cell 7.2v 1500mAH NiMH transmitter battery. If you decide to

replace the stock battery with a Li-Po battery, please observe the following:

Use ONLY a 2 Cell 7.4v Li-Po battery of desired capacity. DO NOT USE A 3 CELL 11.1V LI-PO BATTERY.

You MUST remove the battery from the transmitter to charge the battery.

Do NOT use the charger included with the transmitter to charge a Li-Po battery. You MUST use a dedicated Li-Po battery

charger.

When you change the connector on your Li-Po battery, please observe correct polarity.

CHARGING THE TRANSMITTER BATTERY

An after-market peak-detection charger can be used to charge the NiMH transmitter battery, however, the battery must

rst be removed from the transmitter to be charged. The circuitry within the transmitter will interfere with the peak-detection

charger's normal operation, resulting in over-charging and damaging the battery and possibly the transmitter itself.

1) Plug the round connector from the charger into the charging

jack in the grip of the transmitter.

2) Plug the supplied charger into a 110v AC wall socket. The

charger LED will illuminate red indicating that the charger

is plugged in and charging.

3) Transmitter charger output is 150mAH, therefore, it will take

approximately 10 hours to recharge a fully-discharged

battery. We suggest leaving the charger on overnight.

110v Wall

Outlet

Charger

To Charging

Jack

Charger Specications

Model: OE-156C

Input Voltage: 110v

Tx Output Voltage: 8.5v@150mAH

It's safe to charge a full-discharged battery from 10 to 15 hours. We do not suggest allowing the battery to charge for more

than 15 hours.

If the charger is plugged in to the wall socket, but not to the charging jack in the transmitter, the LED will illuminate green.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRTRONICS MX-V Spezifikationen Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen AIRTRONICS MX-V