AIRTRONICS VG6000 Spezifikationen PDF herunterladen (Seite 9)

Page 9

VG6000

TRANSMITTER STICK TENSION ADJUSTMENT

To adjust the spring tension of the transmitter sticks you need to remove the back of the transmitter case.

First remove the antenna and the NiCd battery pack from the transmitter. Now remove the eight screws

that hold the case back in place, four in the main case, two in the LCD back cover and two on the handle.

Once the screws are removed swing the back of the case away from the transmitter being careful of the

trainer plug wiring.

There are four locations for the stick tension adjustment screws installed because the stick controlling

the throttle is ratcheted and has no tension adjustment. The #1 and #3 screws adjust the tension for the

vertical motion of each stick. The #2 and #4 screws adjust the tension for the horizontal motion of each

stick. To make the tension adjustment use a small phillips type screwdriver to turn the adjustment

screws. Turning the screw clockwise will increase the stick tension, turning it counterclockwise will

decrease the tension. Once you have completed your stick adjustments, replace the case back and

install the NiCd battery pack and antenna. Be careful to line the battery charging port pins when replacing

the back cover.

WARNING:

Any other modifications made to the transmitter other than adjusting stick tension will void any and all

warranties covered be Airtronics Inc.

Screw Locations

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Keine Kommentare

AIRTRONICS VG6000 Spezifikationen Seite 9