AIRTRONICS VG6000 Spezifikationen PDF herunterladen (Seite 15)

Page 15

VG6000

END POINT ADJUSTMENT ( EPA )

EPA will allow you to increase or decrease the total amount of travel the

servo has. EPA is available on all channels and should only be used to

fine tune maximum servo movement. All of your linkages and control

surfaces should be as close as possible to the model specifications

before decreasing or increasing EPA. A good example for EPA would

be when you want to use 2 aileron servos on 2 different channels and

you want to setup both to have the same amount of throws to each other

up and down. NOTE: You must have the FLAPERON feature activated in

order to use 2 sperate aileron servos.

To use EPA, move the cursor to the EPA using the FUNCTION keys. Next use the CH/TIMER key to change to the

channel you want to set your EPA. Next move the stick in the direction you want to increase or decrease and take

note the arrows on the LCD screen. They will point in the direction you are adjusting. EPA can be set independently

from side to side or up and down. Adjustment is from 0 to 150% in each direction.

SERVO CENTERING ( CENT )

Servo centering to a great feature when it comes to setting up a

new model and or setting your servo arms to right at 90 degrees.

When using servo centering, take note that it will change not only

the center position of the servo but as well change both left and

right end points.

Example, you installed a servo arm on your servo but it will not

lineup perfectly 90% to the servo. You now can adjust the servo

centering so now the arm is at 90% of the servo. Servo centering

can be adjusted from 0 to 100% but is best kept within + or - 10%

any more than that you will need to try another servo arm or adjust

your linkage better.

To use CENT, move the cursor to the CENT using the FUNCTION keys. Next use the CH/TIMER key to change to the

channel you want to set your CENT. Adjust using the INC+ or DEC- keys. Adjustment is from +100 to -100.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

AIRTRONICS VG6000 Spezifikationen Seite 15